How to install bulletproof glass

They will subcontract the installation to local glass factories and contractors with greater confidence. But in fact, they do not necessarily have rich experience in bulletproof glass installation. So How to install bulletproof glass?

Firstly, lean the wooden box with glass bottom side down against a solid wall, secure it with a wooden square cushion below, use a crowbar or other tools to pry open the packaging panel, and remove the wooden board. Note: Unpacking tools and hard packaging should not touch the glass to avoid damage to the glass. From the outside to the inside, lift and remove the glass vertically.

Secondly, glass products should be handled firmly, handled with care, and avoid collision and friction. It is strictly forbidden to lift the glass flat! Avoid direct contact with hard objects on the stressed part of the glass, and separate the two sheets with paper. Note: It is strictly forbidden to touch one end of the glass to the ground first!

Finally, a block installation method is adopted. The bullet-proof glass surface is facing the customer activity area. The transparent protective plate should be embedded in the frame on at least three sides, and the embedded depth should not be less than 40mm. The specification should be no less than 10 channel steel or ∠63×5 angle steel. When other profiles are used as the frame, the strength should not be lower than the above profiles.